Adjust Headlamp
Check headlamp alignment. Refer to Service Procedures → Check Headlamp Alignment.
Fork Mounted Fairing
  1. See Figure 1. Grasp adjuster cover (2) and pull forward to release it from posts (3).
  2. Insert flat blade screwdriver in vertical adjuster screw (1).
  3. See Figure 2. Turn vertical adjuster to adjust light beam (4) up or down until top of light beam meets horizontal line (3).
  4. Remove screwdriver and install adjuster cover.
    1. Align adjuster cover with posts.
    2. Press cover firmly onto posts.
1Low beam optical centerline
22.5 cm (0.98 in) below low beam optical centerline
3Headlamp low beam pattern
Figure 1. Alignment of Headlamp Low Beam
1Vertical adjuster
2Adjuster cover
3Post (2)
Figure 2. Headlamp Adjustment
Frame Mounted Fairing
1. See Figure 3 and Figure 4. Insert an appropriately sized Philips #2 screwdriver vertically, behind the chin close-out panel.
2. See Figure 5. Turn the adjuster CW or CCW to adjust the light beam (3) until the top edge meets horizontal line (2).
Figure 3. Headlamp Adjuster
1Fairing
2Headlamp adjuster
Figure 4. Headlamp Adjuster (view from under fairing)
1Low beam optical centerline
2Top edge of headlamp beam
3Headlamp low beam pattern
Figure 5. Alignment of Headlamp Low Beam