WARNINGRider and passenger safety depend upon the correct installation of this kit. Use the appropriate service manual procedures. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00333b)
WARNINGPosition footpegs so rider can operate foot controls without interference. Failure to have full access to foot controls can cause loss of control, which could result in death or serious injury. (00313a)
WARNINGMount the footpegs so they will not strike the ground during cornering. Footpegs striking the ground during cornering can cause loss of control, resulting in death or serious injury. (00458c)
NOTE
- Highway pegs are intended to provide an alternative foot position while rider is seated in a normal riding position. Mounts are not intended to be used as lift points, tie downs, steps and the like or for mounting anything other than the appropriate footpegs. Misuse may cause damage to the assemblies, vehicle or rider and will constitute an abuse case of the parts.
- Due to vehicle assembly variations and close proximity, vehicles with lower fairings may need to be adjusted to prevent contact and potential paint damage. See service manual.
- If clamp position is too low on engine guard, it may contact the ground during cornering. Be aware of when making a decision of final location for the highway peg mount.
- It is recommended footpeg be placed in an orientation that folds up and rearward.
Highway pegs can be adjusted for rider comfort.
See Figure 1. Brackets need to be mounted as shown.
| 1. | See Figure 2. Loosen screws (2). | |
| 2. | NOTE Keep mount at highest point of the mounting zone and facing rider as shown. | |
| 3. | Tighten screws. a. Hand tighten each screw. b. Verify position. c. Alternately tighten both screws. Torque: 27.1 N·m (20 ft-lbs) Highway peg screw |
| 1 | Left side |
| 2 | Right side |
Figure 1. Left and Right Markings
| 1 | Mounting zone |
| 2 | Screw (2) |
Figure 2. Highway Peg (Left side)
Figure 3. Highway Footpegs