1 | Speedometer |
2 | Odometer |
3 | Clock |
4 | Text message |
1 | Software |
2 | Calibration |
MESSAGE | DESCRIPTION |
---|---|
BUELL WISCONSIN USA | Introductory text displayed when ignition key is turned on. |
SYSTEM VOLTAGE | Battery low voltage lamp is lit. See Controls and Indicators → Warning Lamps. |
CT COLD | Flashes on the screen until the engine has reached normal operating temperature.
See Controls and Indicators → Coolant Temperature. |
SERVICE XXX | Service interval is due at the displayed number of km (mi) . This message is displayed on the first startup after the service odometer falls below 322 km (200 mi) and 1,609 km (1000 mi) thresholds. |
SERVICE NOW | Service odometer has elapsed. Vehicle is due for regular maintenance (refer to
Maintenance Scheduling → Regular Service Intervals: Buell Models → Regular Service Intervals: 2010 Buell 1125 Models).
This message is displayed on each startup until service counter is reset. See
Controls and Indicators → Instrument Cluster Configuration
to reset the service counter after maintenance has been completed. |
SIDE STAND (HDI models) | The sidestand is not in the fully retracted position. On HDI models, the vehicle shuts off
power to the ignition and fuel pump when the sidestand is down while the vehicle is in gear and the clutch is released. |
TIPPED KEY OFF | The bank angle sensor has been tripped. The vehicle shuts off power to the ignition and
fuel pump when the tip angle is greater than a predetermined limit. The four way flashers also
flash while vehicle is on its side. Turn the key switch to OFF, stand vehicle upright, and restart
the motorcycle. |
ENTER PIN | Displayed when the ignition is first turned on while the security system is armed. See
Controls and Indicators → SECURITY SYSTEM. |
THEFT ERROR | A problem has been detected with the security system or serial communication has been lost. See a Buell dealer for service.
See Controls and Indicators → SECURITY SYSTEM. |
LOCKED OUT | Twenty consecutive PIN entry failures have been made, causing the instrument cluster to
lock out for 30 minutes. A count down timer is displayed to show the number of remaining minutes
until the PIN can be re-entered. See Controls and Indicators → SECURITY SYSTEM. |
COMM ERROR | A communications error has occurred. The instrument cluster has failed to receive
messages from the ECM. If problem persists, see a Buell dealer for service. NOTE: When the COMM ERROR message is displayed on the LCD screen, turning the key switch to OFF then back to ON will change the displayed message to THEFT ERROR. |