Remove
Del Mar
1. Remove seat. See Operation → Seat.
2. See Figure 1. Remove screws (1).
3. Lift rear of top cover (2) straight up to disengage from mounting grommets (3).
4. Feed the Universal Serial Bus (USB) cover (4) through top cover and remove top cover (2).
Install
1. See Figure 1. Position top cover (2) and feed USB cover through top cover.
2. Install top cover (2) to mounting grommets (3) lower rear into position. Install screws (1). Tighten.
Torque: 5.9–6.5 N·m (52–58 in-lbs) Cover, top, screws
3. Install seat. See Operation → Seat.
1Screw (5)
2Top cover
3Mounting grommet (2)
4USB port and cover
5Retainer (2)
Figure 1. Top Cover
Remove
Mulholland
1. See Figure 2. Remove screws (1).
2. Remove screw (2).
3. Grab sides of top cover (3) and lift top cover off of side tabs.
Install
1. See Figure 2. Guide top cover (3) over USB port (4).
2. Guide brake lines and cable through openings on top cover.
3. See Figure 3. Engage side tabs (4).
4. Verify brake lines and cable (2) are properly routed in top cover openings and not pinched.
5. See Figure 2. Install screw (3). Do not tighten.
6. Install screws (2). Tighten.
Torque: 12.9–14.2 N·m (10–10 ft-lbs) Top cover assembly side screws
7. Tighten screw (3).
Torque: 5.9–6.5 N·m (52–58 in-lbs) Top cover center screw
1Screw (6)
2Screw
3Top cover assembly
4USB port and cover
Figure 2. Top Cover Assembly
1Top cover
2Brake line and cable
3USB port and cover
4Tab
5Screw (3)
Figure 3. Top Cover Installed