Arming
When the motorcycle is parked and the OFF/RUN switch is set to OFF, the security system arms automatically within five seconds if no motion is detected. Even when the fob is present, the system will arm.
On arming, the turn signals will flash twice and the siren will chirp twice. While armed, the indicator lamp in the speedometer face will flash every three seconds.
NOTE
The system must be in the Chirp Mode for the siren to chirp on arming or on disarming. See SECURITY SYSTEM → Siren Chirp Mode (Confirmation).
Disarming
Once disarmed, the rider may ride or move the motorcycle for parking, storage or service without setting off the alarm.
Fob: An armed security system is automatically disarmed when the fob is present and the OFF/RUN switch is set to RUN.
When the system disarms, the siren will chirp once and the security indicator lamp will illuminate for a solid four seconds and then turn off.
Personal Identification Number (PIN): If the fob is misplaced or if the present fob fails to communicate, the system can be disarmed with the Personal Identification Number (PIN). Refer to SECURITY SYSTEM → Arming and Disarming → Entering a PIN to Disarm Security System.
Disarming with a PIN
NOTE
  • At any time during a PIN disarm, if the fob is brought within range of the motorcycle, the security system will disarm when the system receives the coded signal from the fob.
  • If a mistake is made while entering PIN, wait two minutes before another disarming attempt.
  • The security system will remain disarmed until the OFF/RUN switch is set to OFF.
Table 1. Entering a PIN to Disarm Security System
STEP
NO.
ACTION
WAIT FOR CONFIRMATION
NOTES
1
If necessary, verify the current 5-digit PIN.
Should be recorded on wallet card.
2
Push the OFF/RUN switch to RUN.
The odometer window display will show ENTER PIN.
3
Press and release the left turn signal switch.
In the odometer window, a flashing 1 will appear.
4
Increment the digit by tapping the left turn signal until the odometer window displays the first digit of the PIN.
The first digit in the odometer will be the first digit in the PIN.
5
Press right turn switch 1 time.
The first digit is stored and the next digit will flash.
Serves as enter key.
6
Increment the second digit using the left turn switch until the digit reaches the second digit of the PIN.
The second digit in the odometer will be the second digit in the PIN.
7
Press right turn switch 1 time.
The second digit is stored and the next digit will flash.
Serves as enter key.
8
Increment the third digit using the left turn switch until it reaches the third digit of the PIN.
The third digit in the odometer will be the third digit in the PIN.
9
Press right turn switch 1 time.
The third digit is stored and the next digit will flash.
Serves as enter key.
10
Increment the fourth digit using the left turn switch until it reaches the fourth digit of the PIN.
The fourth digit in the odometer will be the fourth digit in the PIN.
11
Press right turn switch 1 time.
The fourth digit is stored and the next digit will flash.
Serves as enter key.
12
Increment the fifth digit using the left turn switch until it reaches the fifth digit of the PIN.
The fifth digit in the odometer will be the fifth digit in the PIN.
13
Press right turn switch 1 time.
The fifth digit is stored. The security system indicator lamp stops blinking.
Smart Security System is disarmed.