NOTICE
There are no serviceable parts inside the unit; leave all servicing to qualified service personnel. Disassembly of the unit could result in equipment damage and/or equipment malfunction. (00172a)
Speedometer
WARNINGTravel at speeds appropriate for road and conditions and never travel faster than posted speed limit. Excessive speed can cause loss of vehicle control, which could result in death or serious injury. (00008a)
The speedometer registers miles per hour (U.S. models only), kilometers per hour (international models only) or is dimensioned in both mph and km/h for required markets.
Instrument backlighting activates after a slight delay. Changes to ambient lighting, such as going through a tunnel, may briefly change backlighting.
Fuel
See Figure 1. The fuel gauge displays eight bars when the fuel tank is full. Each bar represents approximately one-eighth of the total fuel capacity.
Odometer Display
Refer to Operation → Left Hand Control Switches → Left Hand Control Module (LHCM). Pressing the trip switch (5) with the OFF/RUN/START switch in any position activates the odometer reading.
See Figure 1. The odometer window also provides the following selectable displays:
- Odometer
- Trip odometer A
- Trip odometer B
- Fuel range
- Tachometer
- Clock
Press and release the trip switch to cycle through the displays.
Trip Odometers A and B
To check mileage or to reset trip odometers, the OFF/RUN/START switch must be in the RUN position. Press and release the trip switch on the until the desired trip odometer register, A or B is displayed. An A or B on the right of the display window identifies the trip odometer.
To reset or zero trip odometers, have desired trip odometer in display window. Press the trip switch and hold for approximately three seconds. The shown trip odometer resets to zero.
Fuel Range
The fuel range display shows the approximate mileage available with the amount of fuel left in the fuel tank. With OFF/RUN/START switch in the RUN position, press the trip button until range is displayed.
Tachometer
Press and release the trip switch to cycle through the odometer window displays. The tachometer shows the engine speed in revolutions per minute (rpm).
Clock
The clock displays current time in 12/24 hour format. Press and hold trip button with clock displayed to set time and select 12 or 24 hour format. When setting clock, press trip button to cycle through selections, then hold trip button to make selection.
