1.	See Electrical → LEFT HAND CONTROL MODULE (LHCM) → Install → Slide off Trigger Finger Switch Cap. Remove trigger finger switch cap (1). NOTE To replace the hand control module harnesses on internally wired handlebar, see Chassis → HANDLEBAR. a. Lightly lift trigger finger switch cap away from LHCM to elevate from normal position. b. Using a small screwdriver, carefully pry between trigger finger switch cap and switch plunger. c. Slide trigger finger switch cap off in direction shown.
2.	See Electrical → LEFT HAND CONTROL MODULE (LHCM) → Install → Hand Control Module (Typical). Remove LHCM housing (6). NOTE The LHCM housing screws (5) are captive. a. Loosen screws (5). b. Remove front housing (6).
3.	Remove connectors (3). NOTE The latches on connectors are fragile. Use care when disconnecting. a. See Electrical → LEFT HAND CONTROL MODULE (LHCM) → Install → LHCM Connector (Typical). Using a pick, carefully press connector latch (1) down. b. Use a prying motion on latch while pulling on connector to remove.
4.	See Electrical → LEFT HAND CONTROL MODULE (LHCM) → Install → Hand Control Module (Typical). Release connector latch (2) and rotate switch down.
5.	Remove hand control module. a. Remove hand control module from handlebar. b. Release wires from hand control module. c. Remove hand control module.