Special Tools
DescriptionPart NumberQty.
WHEEL BEARING INSTALLER/REMOVER
HD-44060D
1

1. Remove wheel. See Chassis → FRONT WHEEL or Chassis → REAR WHEEL.
2. Figure 1 Assemble:

Special Tool: WHEEL BEARING INSTALLER/REMOVER (HD-44060D)

a. Lubricate draw down bolt or a suitable threaded rod with two locking nuts.
b. Install nut (2), washer (3) and bearing (4) on screw.
c. Insert assembly through hole in bridge (6).
d. Install ball bearing inside collet (5). Fasten collet and ball bearing to forcing screw (1).
3.
NOTE
  • Figure 2 If the puller bridge does not have adequate support, place a scrap brake disc having the small center hole to support the puller bridge.
  • OE disc removal is not necessary. Place the scrap disc directly over the OE disc mounting screws.
  • If the OE disc has been removed, place tape or other protective material between hub and scrap disc to prevent cosmetic damage.
Remove bearings.
a. Figure 1 Hold end of forcing screw (1) and turn collet (5) to expand edges of collet.
b. Figure 3 Hold end of forcing screw (1) and turn nut (2) to remove bearing from wheel.
c. Remove spacer from inside wheel hub.
d. Repeat on opposite side.
4. Discard all bearings.
1Forcing screw
2Nut
3Washer
4Bearing
5Collet with ball bearing
6Bridge
Figure 1. Gripping Bearing
Figure 2. Using Scrap Brake Disc
1Forcing screw
2Nut
Figure 3. Removing Bearing