1.	See Electrical → MAIN WIRE HARNESS → Install → Main Wire Harness (front). Remove front portion of wire harness. a. Disconnect coolant pump connector (5). b. Disconnect horn connector (3). c. Disconnect front WSS connector (2). d. Remove harness anchor (4). e. Remove clamps (1) as shown.
2.	See Electrical → MAIN WIRE HARNESS → Install → Main Wire Harness (Upper). Remove upper portion of wire harness. a. Disconnect vehicle inlet connector (1). b. Disconnect TCU connector (2). c. Disconnect DLC (3). d. Disconnect fuse block (4). e. Disconnect ECM power (5). f. Disconnect BCM (6). g. Disconnect security antenna (9). h. Remove anchored cable straps (10). i. Remove screw for GND 1 (16).
3.	See Electrical → MAIN WIRE HARNESS → Install → Main Wire Harness (rear). Remove rear portion of wire harness. a. Disconnect BDU connector (9). b. Disconnect jiffy stand sensor connector (7). c. Disconnect accessory connector (6). d. Disconnect brake switch connectors (5). e. Disconnect IMU connector (3). f. Remove ABS module cover. See Chassis → BRAKE LINES → Remove and Install: ABS Module Cover. g. Disconnect ABS connector (4). h. Remove anchor (10). i. Remove anchored cable straps (8). j. Remove screws (1).
4.	See Electrical → MAIN WIRE HARNESS → Install → Main Wire Harness (right). Slide coolant pump forward on coolant pump bracket.
5.	Remove right side portion of wire harness. a. Disconnect EVPT connector (3). b. Remove anchored cable straps (1).
6.	Remove main wire harness.