Special Tools
| Description | Part Number | Qty. |
|---|---|---|
| WHEEL BEARING INSTALLER/REMOVER | HD-44060D | 1 |
NOTE
- Front wheel: Install bearing on the brake disc or left side first.
- Rear wheel: Install bearing on the brake disc or right side first.
- Install ABS bearing on the brake disc side of the wheel.
| 1. | See Figure 1. Assemble wheel bearing installer/remover. Special Tool: WHEEL BEARING INSTALLER/REMOVER (HD-44060D) a. Lubricate draw down bolt or a suitable threaded rod with two locking nuts. b. Insert threaded rod (1) through support plate (2). c. Insert assembly through wheel. d. Place new bearing on threaded rod (1). NOTE
e. Install pilot (6), bearing (5), washer (4) and nut (3) over rod. | |
NOTICE Replace both bearing assemblies even if one assembly appears to be good. Mismatched bearings can lead to excessive wear and premature replacement. (00532c) | ||
| 2. | Install bearings. a. Hold hex end of threaded rod (1) and turn nut (3). b. Bearing is fully seated when nut can no longer be turned. c. Remove tool. d. Install spacer sleeve inside wheel hub. e. Reverse tool. f. Install opposite side bearing. | |
| 3. | Install wheel. See Chassis → FRONT WHEEL or Chassis → REAR WHEEL. |
| 1 | Threaded rod |
| 2 | Support plate |
| 3 | Nut |
| 4 | Washer |
| 5 | Bearing |
| 6 | Pilot |
Figure 1. Installing Wheel Bearing