NOTICE

This device is sensitive to electrostatic discharge (ESD). To prevent damage to the device, always touch the motorcycle frame or a grounded surface before handling. (00588c)

1.	See Chassis → ABS MODULE → Install → ABS Module Connections. Disconnect ABS connector (4).
2.	Position rear frame (3) as required to remove banjo bolts (1).
3.	Discard gasket washers (2).
4.	Remove screws (5).
5.	Remove ABS module and bracket assembly (6).
6.	See Chassis → ABS MODULE → Install → ABS Module Bracket. Remove ABS module from bracket. a. Remove screws (3). b. Remove ABS module (1) from bracket (2).