1.	See Electrical → RIGHT HAND CONTROL MODULE (RHCM) → Install → RHCM. Remove housing (1). NOTE To replace the hand control module harnesses on internally wired handlebar, see Chassis → HANDLEBAR. a. Loosen screws (2). b. Remove front housing (1).
2.	Remove right hand grip. See Chassis → HAND GRIPS.
3.	See Electrical → RIGHT HAND CONTROL MODULE (RHCM) → Install → RHCM Connectors. Disconnect connectors (1). NOTE The latches on connectors are fragile. Use care when disconnecting. a. Using a pick, carefully press connector latch (2) down. b. Use a prying motion on latch while pulling on connector to remove.
4.	See Electrical → RIGHT HAND CONTROL MODULE (RHCM) → Install → RHCM. Remove right hand control module. a. Loosen screw (3). b. Release locator pin (4). c. Remove RHCM (1).