Left-Hand Control Module
Right-Hand Control Module
Instrument Module
See Your Motorcycle → Primary Controls and Service Components → Controls and Service Components (Typical). The Instrument Module (IM) (2) displays vehicle instrumentation including speedometer, odometer, charge status and range, icons, and telltales. See Operation → Instruments.
Brakes
WARNING
Do not position fingers between hand control lever and handlebar grip. Improper hand positioning can impair control lever operation and cause loss of vehicle control, which could result in death or serious injury. (00032a)
Front brake lever: See Your Motorcycle → Primary Controls and Service Components → Controls and Service Components (Typical). The front brake lever (4) controls the front brake. Operate the hand lever with the fingers of the right hand.
Rear brake pedal: See Your Motorcycle → Primary Controls and Service Components → Controls and Service Components (Typical). The rear brake pedal (4) activates the rear wheel brake.
WARNING
Do not apply brake strongly enough to lock the wheel. A locked wheel will skid and can cause loss of vehicle control, which could result in death or serious injury. (00053a)
Apply brakes evenly to prevent wheels from locking up. A balance between rear and front brake is best.
Throttle Twist Grip
Accelerate: See Your Motorcycle → Primary Controls and Service Components → Controls and Service Components (Typical). Slowly twist throttle twist grip (5) backward (toward rear of motorcycle) to increase speed.
Decelerate: Slowly twist throttle control grip forward (toward the front) to decrease speed.
OFF/RUN Switch
NOTE
The headlamp and tail lamps operate when the OFF/RUN switch is in the RUN position.
Fork Lock
WARNING
Do not operate vehicle with forks locked. Locking the forks restricts the vehicle's turning ability, which could result in death or serious injury. (00035a)
NOTICE
Protect your vehicle against theft. Failure to lock the motorcycle after parking could result in theft and/or equipment damage. (00151b)
See Figure 1. The fork lock is located in the triple clamp on the right side and is locked with the key. The fork lock also has a sensor that detects whether or not it is engaged. The system will not allow propulsion while the fork lock is engaged. See Propulsion Interlocks in Operation → Instruments.
Using the fork lock immediately after parking your motorcycle will discourage unauthorized use or theft.
  1. Turn fork to full left position.
  2. Insert key into fork lock.
  3. Turn key to right position (clockwise).
  4. Remove key.
  5. To unlock fork, insert key into fork lock and turn to the left position (counter-clockwise). Remove lock key.
  6. Check steering for proper operation by turning the handlebars through the full operating range. Handlebars should turn smoothly without binding.
Figure 1. Fork Lock (typical)